11
Cisco Multiband Wall-Mount Antenna (AIR-ANTM5560P-R)
OL-6847-01
Installation Instructions
Figure 6
Mounting the Antenna on a Wall
To mount the antenna on a wall, follow these steps:
Step 1
Choose a location for mounting.
Step 2
If an extension coaxial cable is used, connect it to the access point and extend the coaxial cable to the
location for mounting the antenna.
Step 3
Attach the antenna to the molded antenna mount using the four provided 8-32 nylon lock nuts.
Step 4
Attach the antenna mount to the articulating arm (all mounting hardware is provided):
a.
Place a 1/4-in. lock washer, then a 1/4-in. flat washer on a 1/4-20 x 1-1/4-in. machine screw.
b.
Insert the screw and washers, first through the molded antenna mount, then the articulating arm.
c.
Secure the articulating arm to the molded antenna mount using a 1/4-20 hex nut.
Step 5
Find the molded wall mount and position it on the mounting surface. Use a pencil to mark the location
of the mounting holes. There are four holes for wall-mounting, one in each corner.
Step 6
Using a 3/16-in. (4.7 mm) drill bit, drill holes for the screws at the locations you marked in
Step 5
.
Step 7
Route the cable either up or down from the wall or corner.
Step 8
Install a wall anchor in each hole.
Step 9
Line up the mounting holes on the molded wall mount with the pilot holes and start one of the provided
8-18 x 3/4-in. self-tapping Phillips screws in each hole.
Step 10
Tighten the screws with a Philips screwdriver.
Step 11
Attach the articulating arm to the molded wall mount (all hardware is provided):
a.
Place a 1/4-in. lock washer, then a 1/4-in. flat washer on a 1/4-20 x 1-1/4-in. machine screw.
b.
Insert the screw and washers, first through the molded wall mount, then the articulating arm.
c.
Secure the articulating arm to the molded wall mount using a 1/4-20 hex nut.
1
Wall anchors
2
Molded wall mount
3
8-18 x 3/4-in. self-tapping Phillips screws
4
Articulating arm
5
Molded antenna mount
2
5
4
1
3
3
135159
