6-5
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
OL-11503-01
Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
Configuring Fast Ethernet Interfaces
Verifying the Host Name and Password
To verify that you configured the correct host name and password:
Step 1
Enter the
show config
command:
Router(config)#
show config
Using 1888 out of 126968 bytes
!
version XX.X
.
.
.
!
hostname Router
!
enable secret 5 $1$60L4$X2JYOwoDc0.kqa1loO/w8/
.
.
.
Step 2
Check the host name and encrypted password displayed near the top of the command output.
Step 3
Exit global configuration mode and attempt to re-enter it using the new enable password:
Router#
exit
.
.
.
Router con0 is now available
Press
RETURN
to get started.
Router>
enable
Password:
guessme
Router#
Tips
If you are having trouble, check the following:
•
Caps Lock
is off.
•
You entered the correct passwords. Passwords are case sensitive.
Configuring Fast Ethernet Interfaces
To configure the FE interface, complete the following tasks, beginning in global configuration mode:
Command
Purpose
Step 1
Router(config)# interface fastethernet 0/0
Router(config-if)#
Enter interface configuration mode. You have
entered interface configuration mode when the
prompt changes to
Router(config-if)#.
Step 2
Router(config-if)# ip address 172.16.74.3
255.255.255.0
Assign an IP address and subnet mask to the
interface.
Summary of Contents for MWR 1941-DC - 1941 Mobile Wireless Router
Page 49: ...P A R T 1 Implementing the MWR 1941 DC Router in an IP RAN ...
Page 50: ......
Page 107: ...P A R T 2 Implementing the MWR 1941 DC Router in a Cell Site DCN ...
Page 108: ......