C H A P T E R
2-1
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
OL-11503-01
2
Cisco IOS Software Basics
This chapter describes what you need to know about the Cisco IOS software before you configure the
router using the command-line interface (CLI). This chapter includes the following:
•
Getting Help, page 2-1
•
Understanding Command Modes, page 2-2
•
Undoing a Command or Feature, page 2-3
•
Saving Configuration Changes, page 2-3
•
Where to Go Next, page 2-3
Understanding these concepts will save time as you begin to use the CLI. If you have never used the
Cisco IOS software or need a refresher, take a few minutes to read this chapter before you proceed to the
next chapter.
If you are already familiar with the Cisco IOS software, proceed to Part 2,
“Implementing the MWR
1941-DC Router in an IP-RAN”
.
Getting Help
Use the question mark (?) and arrow keys to help you enter commands:
•
For a list of available commands, enter a question mark:
Router>
?
•
To complete a command, enter a few known characters followed by a question mark (with no space):
Router>
s?
•
For a list of command variables, enter the command followed by a space and a question mark:
Router>
show ?
•
To redisplay a command you previously entered, press the up arrow key. You can continue to press
the up arrow key for more commands.
Summary of Contents for MWR 1941-DC - 1941 Mobile Wireless Router
Page 49: ...P A R T 1 Implementing the MWR 1941 DC Router in an IP RAN ...
Page 50: ......
Page 107: ...P A R T 2 Implementing the MWR 1941 DC Router in a Cell Site DCN ...
Page 108: ......
