4-28
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
78-13983-08
Chapter 4 Configuring the MWR 1941-DC in an IP-RAN
Monitoring and Managing the MWR 1941-DC
network 10.0.0.0 0.255.255.255 area 51
default-information originate metric 100 metric-type 1
distribute-list 11 out
distance 120
!
ip route 64.102.16.25 255.255.255.255 FastEthernet0/0
ip route 64.102.16.25 255.255.255.255 192.168.1.10
!
Notes
•
Keepalives must be set for all Ethernet interfaces to ensure proper redundant behavior. A keepalive
value of 1 has been selected for maximum responsiveness.
•
Configuring
no ip proxy-arp
is helpful to avoid confusion with routes and ARP caches.
•
In a redundant configuration, both MWR 1941-DCs share a common IP address for their Multilink
interface.
Monitoring and Managing the MWR 1941-DC
You can use Cisco’s network management applications, such as CiscoWorks2000 for Mobile Wireless
(CW4MW), to monitor and manage aspects of the MWR 1941-DC.
To enable remote network management of the MWR 1941-DC, do the following:
Step 1
At the privileged prompt, enter the following command to access configuration mode:
Router#
configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Step 2
At the configuration prompt, enter the following command to assign a host name to each of the network
management workstations:
Router(config)#
ip host
hostname ip_address
Where
hostname
is the name assigned to the Operations and Maintenance (O&M) workstation and
ip_address
is the address of the network management workstation.
Step 3
Enter the following commands to create a loopback interface for O&M:
Router(config)#
interface loopback
number
Router(config-if)#
ip address
ip_address subnet_mask
Step 4
Exit interface configuration mode:
Router(config-if)#
exit
Step 5
At the configuration prompt, enter the following command to specify the recipient of a Simple Network
Management Protocol (SNMP) notification operation:
Router(config)#
snmp-server host
hostname
[
traps
|
informs
] [
version
{
1
|
2c
|
3
[
auth
|
noauth
|
priv
]}]
community-string
[
udp-port
port
] [
notification-type
]
Where
hostname
is the name assigned to the CW4MW workstation with the
ip host
command in
Step 2
.
Summary of Contents for MWR 1941-DC - 1941 Mobile Wireless Router
Page 49: ...P A R T 1 Implementing the MWR 1941 DC Router in an IP RAN ...
Page 50: ......
Page 107: ...P A R T 2 Implementing the MWR 1941 DC Router in a Cell Site DCN ...
Page 108: ......