Figure 29: Two Post Slider Identification
Check for marking on the sliders; slide the inner sliders to adjust the length.
1
Step 2
Integrate the two post slider with the rack.
The slider is fitted on to an ETSI rack using an adapter (refer the following image). The formed surface must always face
the inner side of the rack post. On the front side, insert only the top most screw of the slider (48-101524-01) and tighten
it to a torque value of 4.65 N-m. On the rear side, insert three screws (48-101524-01) and tighten them to a torque value
of 4.65 N-m.
Hardware Installation Guide for Cisco NCS 1004
30
Install Cisco NCS 1004
Install Two Post Slider into an ETSI Rack
