Figure 31: Four Post Slider Identification
Slide and adjust the length of the slider arm.
1
Step 2
Integrate the four post slider with the rack.
The slider is fitted on to an ETSI rack using an adapter (refer the following image). The formed surface must always face
the inner side of the rack post. On the front side, insert only the top most screw of the slider (48-101524-01) and tighten
it to a torque value of 4.65 N-m. On the rear side, insert five screws (48-101524-01) and tighten them to a torque value
of 4.65 N-m.
Hardware Installation Guide for Cisco NCS 1004
32
Install Cisco NCS 1004
Install Four Post Slider into an ETSI rack
