tunnel-id
To specify the ID of the GMPLS UNI tunnel, use the
tunnel-id
command in GMPLS UNI controller
tunnel-properties configuration sub-mode.
tunnel-id number
Syntax Description
Specifies the tunnel
ID.
number
Command Default
None
Command Modes
GMPLS UNI controller tunnel-properties configuration
Command History
Modification
Release
This command is
introduced.
Release
7.0.1
Example
The following example shows how to specify a tunnel ID.
RP/0/RP0/CPU0:ios(config)#mpls traffic-eng
RP/0/RP0/CPU0:ios(config-mpls-te)#gmpls optical-uni
RP/0/RP0/CPU0:ios(config-te-gmpls)#controller Optics0/0/0/0
RP/0/RP0/CPU0:ios(config-te-gmpls-cntl)#tunnel-properties
RP/0/RP0/CPU0:ios(config-te-gmpls-tun)#tunnel-id 5
RP/0/RP0/CPU0:ios(config-te-gmpls-tun)#
Command Reference for Cisco NCS 1004
103
Commands
tunnel-id