tunnel-properties
To configure tunnel-specific information for a GMPLS UNI controller, use the
tunnel-properties
command
in GMPLS-UNI configuration sub-mode.
tunnel-properties
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
GMPLS UNI configuration
Command History
Modification
Release
This command is
introduced.
Release
7.0.1
Example
The following example shows how to enter the sub-mode to configure tunnel-specific information
for a GMPLS UNI controller.
RP/0/RP0/CPU0:ios(config)#mpls traffic-eng
RP/0/RP0/CPU0:ios(config-mpls-te)#gmpls optical-uni
RP/0/RP0/CPU0:ios(config-te-gmpls)#controller Optics0/0/0/0
RP/0/RP0/CPU0:ios(config-te-gmpls-cntl)#tunnel-properties
RP/0/RP0/CPU0:ios(config-te-gmpls-tun)#
Command Reference for Cisco NCS 1004
104
Commands
tunnel-properties