(Only for trunk optics controllers) Configures the maximum acceptable
Differential Group Delay (DGD) value. The DGD alarm is raised if
DGD exceeds this value.
The range is 0 to 18000 (in the units of 0.01 ps).
dgd-high-threshold dgd-value
Configures the high laser bias current threshold.
The range is 0 to 100%
lbc-high-threshold lbc-value
(Only for trunk optics controllers) Configures the minimum acceptable
Optical Signal to Noise ratio (OSNR) value. The OSNR alarm is raised
if OSNR goes below this value.
The range is 0 to 4000 (in units of 0.01db).
osnr-low-threshold osnr-value
Description of the optics controller.
description description
Configures high receive power threshold. The range is -400 to 300 (in
the units of 0.1 dBm).
rx-high-threshold rx-high
Configures low receive power threshold. The range is -400 to 300 (in
the units of 0.1 dBm).
rx-low-threshold rx-low
Configures high transmit power threshold. The range is -400 to 300 dBm
(in the units of 0.1 dBm).
tx-high-threshold tx-high
Configures low transmit power threshold. The range is -400 to 300 dBm
(in the units of 0.1 dBm).
tx-low-threshold tx-low
Configures the administrative state of the controller. The values are
maintenance or normal.
sec-admin-state
Disables the configuration of the controller.
shutdown
Configures performance monitoring parameters for 30 second, 15 minute,
and 24 hour intervals.
pm
(Only for trunk optics controllers) Configures the transmit power. The
range is -190 to 30 dBm (in the units of 0.1 dBm).
transmit-power transmit-power
Shuts down the transmit laser.
transmit-shutdown
Enables or disables performance monitoring.
perf-mon
{
enable
|
disable
}
Configures the chromatic dispersion threshold.
cd
Configures the differential group delay threshold.
dgd
Configures the laser bias current threshold.
lbc
Configures the laser bias current threshold in percentage.
lbc-pc
Configures the optical Rx power threshold in uW.
opr
Command Reference for Cisco NCS 1004
16
Commands
controller optics