Verifying the Installation of a Fabric Card
The following figure shows the front panel of the fabric card.
Figure 110: FC Front Panel
Attention
LED
2
Status
LED
1
Use the Status LED, located on the faceplate of the FC, to verify the correct installation of the card and the
AFT:
•
When the card is properly installed and no faults are detected, the card status LED turns green.
•
When the card status LED is solid yellow, either software initialization is in progress during bootup or
a fault exists on the board.
•
When the card status LED is blinking yellow, the card is not fully seated.
•
When the card status LED is off, verify that the card is installed correctly. There could be no power
applied to the card, a power fault, or a hardware fault.
Hardware Installation Guide for Cisco NCS 4000 Series
207
Installing Route Processor Cards, Fabric Cards, and Line Cards
Verifying the Installation of a Fabric Card