Table 32: 20-Port 10GE OTN LC Descriptions
Description
State
LED
The LC is properly seated and
operating correctly.
Green
Status
The LC has one or more errors
detected.
Yellow
No power is applied to the LC.
Off
The card needs attention.
Blue
Attention
The card does not need attention.
Off
The link is up (including internal
loopback).
Green
Port
The link is down or a hardware
failure has occurred.
Yellow
The slice is unprovisioned by
software, the optics module is
missing, or the slice has been
powered down.
Off
15 The Attention LED can be lit only by using the hw-module attention-led location CLI command, which is useful for identifying and verifying which card needs
attention.
Physical Characteristics
•
Height
—
11.05 in. (280.6 mm)
•
Width
—
1.55 in. (39.4 mm)
•
Depth
—
14.25 in. (362 mm)
•
Weight
—
5.5 lb (2.5 kg)
2-Port 100GE OTN Line Card
The 2-port 100GE OTN LC (NCS4K-2H-O-K) supports any combination of 100GE and OTU4 interfaces
using Cisco CPAK pluggable optics. Two CPAK receptacles are hosted on the faceplate.
Insert CPAK modules in the 2-port 100GE OTN LC handle side down.
Note
Hardware Installation Guide for Cisco NCS 4000 Series
218
Installing Route Processor Cards, Fabric Cards, and Line Cards
2-Port 100GE OTN Line Card