Because invisible radiation may be emitted from the aperture of the port when no fiber cable is
connected, avoid exposure to radiation and do not stare into open apertures.
Statement 125
Warning
For diverging beams, viewing the laser output with certain optical instruments within a distance of
100 mm may pose an eye hazard. For collimated beams, viewing the laser output with certain optical
instruments designed for use at a distance may pose an eye hazard.
Statement 282
Warning
Prerequisites
Before performing this task, open the front door, if installed.
The system can indicate a hardware failure if you do not follow proper procedures. Remove or install only
one LC at a time. Allow at least 30 seconds for the system to complete its tasks before removing or
installing another LC.
This procedure is traffic-impacting.
Caution
Required Tools and Equipment
•
ESD-preventive wrist strap
•
Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver
Steps
Hardware Installation Guide for Cisco NCS 4000 Series
236
Removing and Replacing Chassis Components
Removing a Line Card
