The following steps describe how to install an FC card.
Figure 32: Installing an FC
Procedure
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the two ESD jacks located
on the front or rear side of the chassis. You can also connect the ESD-preventive wrist strap leash to any bare
metal surface on the chassis.
Step 2
Remove the FC from its antistatic packaging.
Step 3
Place one hand under the card to support and position the card for insertion into the card cage slot. Avoid
touching the card circuitry or any connectors.
Hardware Installation Guide for Cisco NCS 4000 Series
64
Installing Route Processor Cards, Fabric Cards, and Line Cards
Installing a Fabric Card