Figure 13: Attaching Aid Brackets to the Rack for NCS 4016
Step 2
Once the chassis has been installed, remove the aid brackets. Loosen the two screws from the aid brackets
and take off the rack.
Keep the aid brackets in case of future chassis relocation.
Tip
What to do next
To accommodate equipment racks with different mounting hole patterns, the aid brackets have groups of
screw holes on either side.
The mounting holes in the aid brackets are spaced so that one mounting hole in each hole group aligns with
a corresponding hole in the equipment rack. By using the corresponding mounting hole (in the same hole
group) on the opposite side of the rack, you can keep both the aid brackets leveled.
Hardware Installation Guide for the Cisco NCS 4000 Series
18
Mounting the Chassis
Installing the Aid Brackets
Summary of Contents for NCS 4000 Series
Page 2: ......