To accommodate equipment racks with different mounting-hole patterns, the chassis mounting
brackets have groups of screw holes on either side. The mounting holes in these rails are spaced so
that one hole in each hole group aligns with a hole in the equipment rack or the optional center-mount
bracket. Use the corresponding mounting hole (in the same hole group) on the opposite side of the
chassis to level the chassis in the rack.
Note
Step 7
Use the screwdriver to fully tighten the screws. Tighten the screws to a torque value of 22 in-lb (2.5 N-m).
Hardware Installation Guide for the Cisco NCS 4000 Series
28
Mounting the Chassis
Mounting the Chassis into a Rack
Summary of Contents for NCS 4000 Series
Page 2: ......