• 2-Port 100GE OTN (NCS4K-2H-O-K) Line Card - See datasheet at
https://www.cisco.com/c/en/us/
products/collateral/optical-networking/network-convergence-system-4000-series/data_sheet_
c78-729398.html
.
• 2-Port 100GE DWDM (NCS4K-2H-W) Line Card- See datasheet at
https://www.cisco.com/c/en/us/
products/collateral/optical-networking/network-convergence-system-4000-series/data_sheet_
c78-729434.html
Installing a Route Processor, Fabric Card, or Line Card
Class 1 Laser Product.
Statement 113
Warning
Because invisible radiation may be emitted from the aperture of the port when no fiber cable is connected,
avoid exposure to radiation and do not stare into open apertures.
Statement 125
Warning
Prerequisites
Before performing this task, open the front door, if installed.
Tools and Equipment
• ESD-preventive wrist strap
• Number-2 Phillips screwdriver
• Route processor (RP): Cisco PID NCS4K-RP
• Fabric card (FC) in NCS 4016 : Cisco PID: NCS4016-FC-M or NCS4016-FC2-M
• Fabric card (FC) in NCS 4009: Cisco PID: NCS4009-FC-S or NCS4009-FC2-S or NCS4009-FC2F-S
The FC in NCS 4009 contains only one ejector lever and one captive screw.
Note
For easier installation, install all FCs before securing any fasteners.
Tip
• Auxiliary Fan Tray (AFT): Cisco PID: NCS4009-FAN-FC F
• Line card: Cisco PID: NCS4K-2H-W, NCS4K-2H-O-K, NCS4K-20T-O-S, NCS4K-24LR-O-S,
NCS4K-2H10T-OP-KS, or NCS4K-4H-OPW-QC2
Remove or install only one line card at a time. Allow at least 30 seconds for the
chassis to complete its tasks before removing or installing another line card. The
chassis may indicate a hardware failure if you do not follow proper procedures.
Caution
Steps
Hardware Installation Guide for the Cisco NCS 4000 Series
35
Installing Route Processor Cards, Fabric Cards, and Line Cards
Installing a Route Processor, Fabric Card, or Line Card
Summary of Contents for NCS 4000 Series
Page 2: ......