C H A P T E R
9
Installation Roadmap for NCS 4009
This chapter lists the steps to install the Cisco NCS 4009 chassis and its components and prepare the system
for operation.
•
Installation Roadmap, page 147
Installation Roadmap
This table lists the steps to install the Cisco NCS 4009 chassis and its components and prepare the system for
operation. Use this table as a checklist to ensure that all components are properly installed in the correct order.
For information about a step, see the respective book or section of this installation guide.
Table 23: Overview of Installation Steps
See
Step
Cisco Network Convergence System 4000 Series
Unpacking, Moving, and Securing Guide
Verify that the chassis is secured in the rack.
For ease of installation, the cosmetic door
should be removed.
Note
Installing the Chassis Ground Cable, on page 169
Ground the chassis.
Installing Power Components, on page 163
Verify that the power components are installed.
Verify that the ECU is installed.
Removing the Fan Tray, on page 257
Verify that the fan trays are installed.
Disconnecting AC or DC Power, on page 189
Connect the AC or DC power cord.
Powering On the Chassis, on page 191
Power on the chassis.
Installing Route Processor Cards, Fabric Cards, and
Line Cards, on page 193
Install cards and remaining components in the chassis.
Replacing the Front Door, on page 251
Re-install the cosmetic door.
Hardware Installation Guide for Cisco NCS 4000 Series
147
