Steps
To remove a power module from the front of a power tray, follow these steps:
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to the ESD jack on the front side of the FCC
(see
Preventing Electrostatic Discharge, on page 11
). You can also connect the ESD-preventive wrist strap leash to any
bare metal surface on the FCC.
Step 2
Using the screwdriver, unscrew the ejector lever screw.
Figure 62: Removing a PM from a Power Tray
Power module (PM)
3
Ejector lever screw
1
Ejector lever
2
Step 3
Rotate the ejector lever down to unseat the PM.
Step 4
Slide the PM out of its bay in the power tray while supporting it with your other hand.
Removing the FCC Ground Cable
This section describes how to remove the FCC ground cable on the Cisco NCS 6000 FCC.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
103
Removing and Replacing Chassis Components
Removing the FCC Ground Cable