You can install the thermoplastic sleeve around the base of the CXP2 before you install the CXP2, as shown
in the following figure.
You can leave the sleeve on the CXP2 optical module while it is installed in the fabric card.
Note
If a CXP2 is already installed, you can install the thermoplastic sleeve around the base of the CXP2 before
you remove it from a transceiver socket, as shown in the following figure.
Alternatively, you can remove a CXP2 optical module (with or without the thermoplastic sleeve) and hold it
in the provided silicon foam pad, as shown in the following figures.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
121
Removing and Replacing Chassis Components
Removing an S2 Fabric Card