Craft panel display cover
6
Three door latches:
Door stop latch, top and bottom (700-39150-01)
Door latch, middle (700-46854-01)
3
For each vertical cable trough
1
Align the guide pins on the rear of the vertical cable trough with the positioning holes on the front of the FCC.
2
Loosely insert eight pan-head screws, and then use the screwdriver to tighten them clockwise to attach the vertical
cable troughs firmly to the front of the FCC. You might need to use a ladder to reach the upper screws.
3
Attach two trough retention brackets to each vertical trough with two 8-32 flat-head screws (two per trough).
4
Using the captive screw, insert the trough retention brackets into each upper and lower horizontal cable troughs (two
screws per side).
Step 3
Reattach the upper and lower horizontal cable management brackets by inserting and tightening the eight pan-head
screws (four per bracket).
Step 4
Attach the three door hinges and the three door latches by using two pan-head screws each.
Step 5
Align the front door (see the following figure) with the three door hinges on the FCC. The door will then drop into
position onto the hinge attachment pins.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
25
Installing the Power Enclosure, Power Trays, and Exterior Cosmetics
Installing the Front Exterior Cosmetics