Step 7
If needed, remove the craft panel located on the front of the FCC (see the above figure). In most cases, it is not necessary
to remove the craft panel although the assembly is a field-replaceable unit (PID NCS-CRFT=).
a) Loosen the four captive screws on the craft display panel.
b) Pull the craft display panel away from the FCC to remove it.
c) Loosen the four captive screws on the sheet metal craft panel.
d) Pull the craft panel away from the FCC to remove it.
Removing the Rear Exterior Cosmetics
To remove the rear exterior cosmetics, follow these steps:
Step 1
Remove the rear door.
a) Open the door and remove the grounding cable by loosening and removing the pan-head screws (
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
94
Removing and Replacing Chassis Components
Removing the Rear Exterior Cosmetics
