Step 2
If applicable, remove the exhaust plenum bracket by removing the eight pan-head screws, four on each side (
Removing the Exhaust Plenum Bracket
Step 3
Remove the two upper and lower horizontal cable management brackets by loosening and removing the eight pan-head
screws (four per bracket).
Step 4
Remove the left and right vertical cable troughs from the rear of the FCC.
We recommend that you use two people to remove the vertical cable troughs, one person to hold the vertical
cable troughs while the other person removes the pan-head screws.
Note
For each vertical trough:
a) Loosen the captive screw on the trough retention brackets (two each side) and swing the brackets away from the
FCC.
b) Loosen and remove the eight pan-head screws from the trough.
Step 5
Pull the trough away and carefully remove it from the FCC.
Removing the Power Components
This section describes how to remove and replace the power components and power enclosure from the Cisco
NCS 6000 Fabric Card Chassis (FCC).
While it is possible to remove power components from the FCC separately, some parts (such as the power
trays) require that other parts be removed first.
Note
We recommend that you remove the power components in the order outlined in this section.
Removing AC Input Power Cords
This section describes how to remove AC input power cords from a power tray.
Prerequisites
Remove the exhaust air deflector from the rear of the Cisco NCS 6000 FCC. Power off the AC PMs in the
tray that you want to disconnect.
Before removal, make sure that the input power cables are not energized.
Note
Required Tools and Equipment
•
ESD-preventive wrist strap
•
6-inch, Number-1 Phillips screwdriver
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
96
Removing and Replacing Chassis Components
Removing the Power Components