Steps
To remove an S2 FC, follow these steps:
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the two ESD jacks on the rear side
of the FCC (see
Preventing Electrostatic Discharge, on page 11
). You can also connect the ESD-preventive wrist strap
leash to any bare-metal surface on the FCC.
Step 2
Identify the card to be removed from the card cage. Use the number-2 Phillips screwdriver or number-2 common
(flat-head) screwdriver to turn the two captive screws on the front panel of the card counterclockwise to loosen it from
the slot.
Figure 71: Removing an S2 FC
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
123
Removing and Replacing Chassis Components
Removing an S2 Fabric Card
