S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-107
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
logging level
logging level
To enable logging messages from a defined facility that have the specified severity level or higher, use
the
logging level
command. To disable logging messages from a defined facility, use the
no
form of this
command.
logging level
facility
severity-level
no logging level
facility
severity-level
Syntax Description
Command Default
None
Command Modes
Global configuration mode
Command History
Examples
This example shows how to enable logging messages from the AAA facility that have a severity level of
2 or higher:
switch#
configure terminal
switch(config)#
logging level aaa 2
switch(config)#
This example shows how to enable error logging messages for the Precision Time Protocol (PTP)
packets:
switch#
configure terminal
switch(config)#
logging level ptp 3
facility
Facility.
To apply the same severity level to all facilities, use the
all
facility.
severity-level
Number of the desired severity level at which messages should be logged.
Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
0
—emergency: System unusable
•
1
—alert: Immediate action needed
•
2
—critical: Critical condition—default level
•
3
—error: Error condition
•
4
—warning: Warning condition
•
5
—notification: Normal but significant condition
•
6
—informational: Informational message only
•
7
—debugging: Appears during debugging only
Release
Modification
5.0(3)U1(1)
This command was introduced.