S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-150
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ntp source
ntp source
To configure the Network Time Protocol (NTP) source, use the
ntp source
command. To remove the
NTP source, use the
no
form of this command.
ntp
source
addr
no
ntp
source
addr
Syntax Description
Defaults
None
Command Modes
Global configuration mode
Command History
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure the NTP source:
switch(config)#
ntp source 192.0.2.3
This example shows how to remove the NTP source:
switch(config)#
no ntp source 192.0.2.3
Related Commands
addr
IPv4 or IPv6 address of the source. The IPv4 address format is dotted decimal,
x.x.x.x. The IPv6 address format is hex A:B::C:D.
Release
Modification
6.0(2)U(2)1
This command was introduced.
Command
Description
show ntp source
Displays information about the NTP source.