S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-58
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
event fanbad
event fanbad
To specify an event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of a
fan bad event, use the
event fanbad
command. To remove the fan bad event criteria, use the
no
form of
this command.
event fanbad fan
number
time
interval
no event fanbad
[
fan
number
]
time
interval
Syntax Description
Defaults
None
Command Modes
Embedded event manager configuration mode
Command History
Usage Guidelines
This command does not require a license.
Examples
This example shows how to specify that an EEM applet runs when a fan bad event occurs:
switch#
configure terminal
switch(config)#
event manager applet bad-applet
switch(config-applet)#
event fanbad time 1200
switch(config-applet)#
fan
number
Specifies a fan number to monitor for a fan bad event. The range is from 1 to 1.
time
interval
Specifies the time interval (in seconds) within which the fan can stay bad. The
range is from 10 to 64000.
Release
Modification
5.0(3)U3(1)
This command was introduced.