S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-100
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
logging console
logging console
To enable logging messages to the console session, use the
logging console
command. To disable
logging messages to the console session, use the
no
form of this command.
logging console
[
severity-level
]
no logging console
Syntax Description
Command Default
None
Command Modes
Global configuration mode
Command History
Examples
This example shows how to enable logging messages with a severity level of 4 (warning) or higher to
the console session:
switch#
configure terminal
switch(config)#
logging console 4
switch(config)#
Related Commands
severity-level
(Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
0
—emergency: System unusable
•
1
—alert: Immediate action needed
•
2
—critical: Critical condition—default level
•
3
—error: Error condition
•
4
—warning: Warning condition
•
5
—notification: Normal but significant condition
•
6
—informational: Informational message only
•
7
—debugging: Appears during debugging only
Release
Modification
5.0(3)U1(1)
This command was introduced.
Command
Description
show logging console
Displays the console logging configuration.
