S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-109
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
logging logfile
logging logfile
To configure the name of the log file used to store system messages and the minimum severity level to
log, use the
logging logfile
command. To disable logging to the log file, use the
no
form of this
command.
logging logfile
logfile-name
severity-level
[
size
bytes
]
no logging logfile
[
logfile-name
severity-level
[
size
bytes
]]]
Syntax Description
Command Default
None
Command Modes
Global configuration mode
Command History
Examples
This example shows how to configure a log file called logfile to store system messages and set its
severity level to 4:
switch#
configure terminal
switch(config)#
logging logfile logfile 4
switch(config)#
logfile-name
Name of the log file to be used to store system messages.
severity-level
Number of the desired severity level at which messages should be logged.
Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
0
—emergency: System unusable
•
1
—alert: Immediate action needed
•
2
—critical: Critical condition—default level
•
3
—error: Error condition
•
4
—warning: Warning condition
•
5
—notification: Normal but significant condition
•
6
—informational: Informational message only
•
7
—debugging: Appears during debugging only
size
bytes
(Optional) Specifies a maximum file size. The default file size is 4194304
bytes and can be configured from 4096 to 4194304 bytes.
Release
Modification
5.0(3)U1(1)
This command was introduced.