S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-157
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ptp
ptp
To enable the Precision Time Protocol (PTP) on an interface, use the
ptp
command. To disable PTP on
an interface, use the
no
form of this command.
ptp
no ptp
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Interface configuration mode
Command History
Usage Guidelines
This command does not require a license.
Examples
This example shows how to enable PTP on an interface:
switch#
configure terminal
switch(config)#
interface ethernet 1/5
switch(config-if)#
ptp
switch(config-if)#
This example shows how to disable PTP on an interface:
switch#
configure terminal
switch(config)#
interface ethernet 1/5
switch(config-if)#
no ptp
switch(config-if)#
Related Commands
Release
Modification
5.0(3)U2(2)
This command was introduced.
Command
Description
feature ptp
Enables or disables PTP on the device.
ptp delay-request
minimum interval
Configures the minimum interval allowed between PTP delay-request
messages when the port is in the master state.
ptp source
Configures the source IP address for all PTP packets.
ptp sync interval
Configures the interval between PTP synchronization messages on an
interface.
ptp vlan
Configures the PTP VLAN value on an interface.