S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-63
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
event memory
event memory
To specify an event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of a
memory threshold, use the
event memory
command. To remove the memory event criteria, use the
no
form of this command.
event memory
[
critical | minor | severe
]
no event memory
[
critical | minor | severe
]
Syntax Description
Defaults
None
Command Modes
Embedded event manager configuration mode
Command History
Usage Guidelines
This command does not require a license.
Examples
This example shows how to specify that an EEM applet runs when a memory threshold is exceeded:
switch#
configure terminal
switch(config)
event manager applet cli-event
switch(config-applet)#
event memory critical
switch(config-applet)#
critical
Specifies a critical alert.
minor
Specifies a minor alert.
severe
Specifies a severe alert.
Release
Modification
5.0(3)U3(1)
This command was introduced.