5-6
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 5 Installing a Cisco Nexus 7018 Chassis
Installing the Bottom-Support Rails on the Rack
Figure 5-1
Positioning the Bottom-Support Rails
Step 2
Use a Phillips torque screwdriver to screw in at least three (four if possible) M6 x 19 mm or 12-24 x 3/4
inch Phillips screws on each end of each rail (using a total of 16 screws for both brackets) as shown in
Figure 5-2
. Tighten each screw to a maximum of 40 in-lb [4.5 N·m]) of torque.
1
For the first and heaviest chassis installed in a
rack, position two bottom-support rails at the
lowest RU on the rack.
2
Allow at least 43.75 inches (111.1 cm)
(25 RU) for each Cisco Nexus 7018 system.
Summary of Contents for Nexus 7004
Page 12: ...Contents xii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 19: ... xix Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 22: ... xxii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...