10-34
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 10 Installing or Replacing Components
Replacing a Supervisor Module
Step 7
Grasp the front edge of the module with one hand and place your other hand under the lower side of the
module to support its weight. Pull the module out of its slot.
Caution
To prevent ESD damage, avoid touching the electronic circuitry and prevent anything else from coming
in contact with its circuitry.
Step 8
If you are removing the module from a Cisco 7010 chassis, rotate the module 90 degrees
counterclockwise so that it is horizontal and you can see the circuitry from above.
Step 9
For the DIMM in the second memory slot from the front of the supervisor module, rotate the two spring
clips away from the DIMM (see Callout 1 in
Figure 10-10
).
Figure 10-10
Removing a 4-GB DIMM
Step 10
Holding the edges of the 4-GB DIMM with your fingers, slide it out of its memory slot (see Callout 2 in
Figure 10-10
) and place it in an antistatic bag.
Step 11
Remove the 8-GB label from the front of the module.
Step 12
Rotate both ejector levers away from the front of the supervisor module.
Step 13
Grasp the front of the module with one hand and place your other hand under the module to support its
weight.
Step 14
Align the module to the open supervisor slot in the chassis and push the module into the slot until it
makes contact with the midplane.
Step 15
Simultaneously push both ejector levers inward until they come in contact with the face of the module.
Step 16
The module should be fully seated in the slot and the captive screws should be aligned with their holes
in the chassis. The EMI gasket should close the gap between this module and the next module.
Step 17
Screw in the two captive screws to the chassis and tighten them to 8 in-lb (0.9 N·m).
1
On the second socket from the front of the
module, rotate both spring clips away from
the DIMM.
3
Remove the “8 GB” label on the front of the
module.
2
Hold the DIMM by its edges and pull it out of
the memory slot.
Summary of Contents for Nexus 7004
Page 12: ...Contents xii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 19: ... xix Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 22: ... xxii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...