10-42
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 10 Installing or Replacing Components
Installing a NAM Module
Note
Alternatively, you can use the
poweroff module
command, but that command requires that you
use the
no poweroff module
command after reinstalling the module. If you use the
out-of-service module
command, you do not need to use another command to bring the module
up when you install it.
b.
Disconnect any cables attached to the front of the module.
c.
Loosen the two captive screws (one on each end of the module) until they are no longer in contact
with the chassis.
d.
Press ejector release buttons on each end of the module to push out the ejector levers.
e.
Simultaneously rotate the two ejector levers outward to unseat the module from the midplane
connector.
f.
With a hand on each ejector, pull the module part way out of its slot in the chassis.
g.
Grasp the front edge of the module and place your other hand under the module to support its weight.
Pull the module out of its slot. Do not touch the module circuitry.
h.
If you are removing the module from a Cisco Nexus 7010 chassis, rotate the module 90 degrees
counterclockwise so that it is horizontal (with the electronics seen from above).
i.
Place the module on an antistatic mat or repack it in its original packing materials.
Step 5
Install the new NAM as follows:
a.
On the replacement NAM, rotate both ejector levers fully away from the front of the module. If
necessary, press the two ejector buttons to release the levers from the front of the module and then
rotate the levers away from the front of the module.
b.
If you are inserting the module into a Cisco Nexus 7010 chassis, rotate the module 90 degrees
clockwise so that the circuitry is seen from the right side.
c.
Align the module to the chassis guides for the open slot, and slide the module into the slot until it
stops with the front of the module being about 1/4 inch (0.6 cm) out from the front of the chassis.
d.
Simultaneously push both ejector levers inward until they come in contact with the face of the
module. The module moves completely into the slot with the front of the module being at the front
of the chassis.
e.
Verify that the ejector levers are fully closed before tightening the captive screws. Failure to fully
seat the module in the midplane connectors can result in error messages or damage to the module.
f.
Tighten the two captive screws on the I/O module to 8 in-lb (0.9 N·m) of torque.
g.
If you disconnected any cables from the front of the module, reconnect those cables to the module.
h.
Verify that the STATUS LED eventurally turns green to show that the module is operational. For
information on the other states indicated by this LED, see the
“NAM-NX1 Module LEDs” section
on page D-5
.
You are ready to install the Prime NAM software on the new module.
Installing the Cisco Prime NAM Software
To install the Cisco Prime NAM software, follow these steps:
Summary of Contents for Nexus 7004
Page 12: ...Contents xii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 19: ... xix Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 22: ... xxii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
