10-72
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 10 Installing or Replacing Components
Replacing the Cable Management Frame on the Cisco Nexus 7018 Chassis
Replacing the Cable Management Frame on the Cisco Nexus
7018 Chassis
This section describes how to remove cable management frame components and install the components
for a replacement frame. The cable management frame includes two lower cable management
assemblies, two upper cable management assemblies, and a top cover.
This section includes the following topics:
•
Required Tools, page 10-72
•
Removing the Cable Management Frame, page 10-72
•
Installing a Cable Management Frame, page 10-76
Required Tools
You need a flat-blade or number 2 Phillips-head screwdriver to loosen or tighten the screws that hold the
cable management assemblies to the chassis.
Removing the Cable Management Frame
When you remove the cable management frame from the Cisco Nexus 7018 chassis, you must remove a
top cover and four cable management assemblies.
Note
Before you can remove the cable management frame from the Cisco Nexus 7018 chassis, you must
remove the front door and its bracket if they are installed on the cable management frame. For
information on removing the front door and its bracket, see the
“Replacing the Front Door and Air Intake
Assemblies on the Cisco Nexus 7018 Chassis” section on page 10-81
.
To remove the cable management frame assemblies, follow these steps:
Step 1
Loosen and remove the eight M4x8 pan-head screws that fasten the top cover to the upper cable
management assemblies and chassis (see
Figure 10-27
).
Summary of Contents for Nexus 7004
Page 12: ...Contents xii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 19: ... xix Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 22: ... xxii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...