10-76
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 10 Installing or Replacing Components
Replacing the Cable Management Frame on the Cisco Nexus 7018 Chassis
Installing a Cable Management Frame
When you install a cable management frame, you attach four cable management assemblies to the
chassis and then attach a top cover to the top two cable management assemblies and the chassis.
To install the cable management frame on the Cisco Nexus 7018 switch chassis, follow these steps:
Step 1
Open the Cable Management kit (69-1961-01) and verify that you have the following parts:
•
2 lower cable management assemblies (800-31343-01)
•
2 upper cable management assemblies (800-31342-01)
•
1 top cover (800-31269-01)
•
8 M4x8 pan-head screws (48-0398-01)
•
18 M4x10 flat-head screws (48-2518-01)
If the kit is not complete, contact TAC and arrange for a complete kit.
Step 2
Attach a lower cable management assembly onto the two hooks that protrude from the lower half of the
left rack-mount bracket that is attached to the Cisco Nexus 7018 switch chassis, and loosely fasten the
assembly to the chassis with four flat-head M4x10 screws as shown in
Figure 10-30
.
Summary of Contents for Nexus 7004
Page 12: ...Contents xii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 19: ... xix Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 22: ... xxii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
