2-13
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 2 Installing a Cisco Nexus 7004 Chassis
Installing the Air Filter
To install storage media in a supervisor module, follow these steps:
Step 1
Insert the USB drive in the LOG FLASH or SLOT0 port.
Step 2
Wait for the reader or port LED to turn green and for a message to appear on the console as follows:
•
If you are installing a USB drive into the log flash reader, the message will end with
“logflash:online.”
•
If you are installing a USB drive into the expansion flash reader, the message will end with
“slot0:online.”
•
If you see an “offline” message or do not see a message, either the USB drive is not fully inserted
or it is improperly formatted.
Make sure that the USB drive is fully inserted inside the reader. If it is fully inserted, either format
the card (see the
Cisco Nexus 7000 Series NX-OS Fundamentals Configuration Guide
) or replace
the USB drive with another that is properly formatted for the reader.
Installing the Air Filter
The Cisco Nexus 7004 air filter is an optional feature (part number N7K-C7004-FAN=). To install an air
filter, follow these steps:
Step 1
Place the air filter over the air intake area on the right side of the chassis and align the eight screw holes
in the filter to screw holes in the chassis.
Step 2
Fasten the air filter to the chassis using eight M3 x 5 mm screws that came with the air filter.. Tighten
the screws to 5 to 7 in-lb (0.56 to 0.79 N.m).
Summary of Contents for Nexus 7004
Page 12: ...Contents xii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 19: ... xix Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 22: ... xxii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
