3-17
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 3 Installing a Cisco Nexus 7009 Chassis
Installing the Chassis
Figure 3-8
Attaching Center-Mount Brackets to the Chassis
c.
Fasten the bracket to the chassis with the five screws previously removed from the front-mount
bracket.
d.
Repeat Steps b and c for attaching the other center-mount bracket to the other side of the chassis.
Step 2
Load the chassis onto a mechanical lift as follows:
a.
Position the mechanical lift next to the shipping pallet that holds the chassis.
b.
Elevate the lift platform to the level of the bottom of the chassis (or no more than 0.25 inches
[0.635 cm] below the bottom of the chassis).
c.
Use at least two persons to slide the chassis fully onto the lift so that the side of the chassis touches
or is close to the vertical rails on the lift. Make sure that the front and rear of the chassis are
unobstructed so you can easily push the chassis into the rack.
1
Position the center-mount bracket with its five
screw holes aligned to the five screw holes in
the chassis.
2
Fasten the bracket to the chassis using five
screws previously used to hold a front-mount
bracket to the chassis.
Summary of Contents for Nexus 7004
Page 12: ...Contents xii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 19: ... xix Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...
Page 22: ... xxii Cisco Nexus 7000 Series Hardware Installation and Reference Guide OL 23069 07 ...