same level as the top of the chassis (see
Figure 5: Installing the Cable Management Frames on a Cisco
Nexus 7004 Chassis, on page 11
2.
Fasten the frame to the chassis with three M3 x 10 mm screws (see Callout 2 in
Cable Management Frames on a Cisco Nexus 7004 Chassis, on page 11
). Tighten the screws to 5 to 7
in-lb (0.56 to 0.79 N.m).
3.
Repeat Steps 1 and 2 to install the other cable management frame to the chassis.
DETAILED STEPS
Step 1
Align the guide pin on one of the two cable management frames to a guide-pin hole of the same size on the front-mounting
bracket that is already attached to the chassis. The top of the frame should be at the same level as the top of the chassis
(see
Figure 5: Installing the Cable Management Frames on a Cisco Nexus 7004 Chassis, on page 11
Figure 5: Installing the Cable Management Frames on a Cisco Nexus 7004 Chassis
Three M3 x 10 mm screws used to fasten the frame to the
chassis (total of six screws for two frames).
2
Guide pins on the cable management frame aligned to
two holes in the front-mount bracket.
1
Step 2
Fasten the frame to the chassis with three M3 x 10 mm screws (see Callout 2 in
Figure 5: Installing the Cable Management
Frames on a Cisco Nexus 7004 Chassis, on page 11
). Tighten the screws to 5 to 7 in-lb (0.56 to 0.79 N.m).
Step 3
Repeat Steps 1 and 2 to install the other cable management frame to the chassis.
Installing a Cisco Nexus 7004 Chassis
11
Installing a Cisco Nexus 7004 Chassis
Installing the Cable Management Frames