S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
4-10
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 4 Installing a Cisco Nexus 7018 Chassis
Installing the Chassis
Figure 4-3
Moving a Cisco Nexus 7018 Chassis onto a Rack
Step 4
Make sure that the screw holes in the chassis mounting brackets align with the screw holes in the vertical
mounting rails.
If you need to reposition the chassis to align the screw holes, you can use the handles on the sides of the
chassis.
Tip
To adjust the placement of the chassis so that the screw holes in the chassis mounting brackets align with
the screw holes in the vertical mounting rails, use the chassis handles shown in
.
Step 5
Use a Phillips screwdriver to screw in nine M6 x 19-mm or 12-24 x 3/4-inch screws in each of the two
chassis mounting brackets (use a total of 18 screws for two mounting brackets) as shown in
.
1
Push the sides of the lower half of the front
side of the chassis.
3
Rack vertical mounting rails.
2
Chassis mounting brackets.
