S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
9-22
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing a Supervisor Module
Caution
To prevent ESD damage, avoid touching the electronic circuitry and prevent anything else from coming
in contact with its circuitry.
Step 8
If you are removing the module from a Cisco 7010 chassis, rotate the module 90 degrees
counterclockwise so that it is horizontal and you can see the circuitry from above.
Step 9
On the second memory slot from the front of the module, rotate both spring clips away from the slot (see
Callout 1 in
Figure 9-8
Adding a 4-GB DIMM
Step 10
Holding the edges of the 4-GB memory board with one hand, slide it into the second memory slot from
the front of the module until the two spring clips click into the DIMM (see Callout 2 in
Step 11
Place an 8-GB label on the front of the module and to the right of the N7K-SUP-1 identifier.
Step 12
Rotate both ejector levers away from the front of the supervisor module.
Step 13
Grasp the front of the supervisor module with one hand and place your other hand under the module to
support its weight.
Step 14
Align the module to the open supervisor slot in the chassis and push the module into the slot until it
makes contact with the midplane.
Step 15
Simultaneously push both ejector levers inward until they come in contact with the face of the module.
The module should be fully seated in the slot and the captive screws should be aligned with their holes
in the chassis. The EMI gasket should close the gap between this module and the next module.
1
On the second memory slot from the front of
the supervisor module, rotate both spring
clips out.
3
Add an 8 GB label to the right of the
N7K-SUP-1 identifier on the front of the
module.
2
Holding the DIMM by its edges, align it to the
second memory slot and push it into place
until the spring clips click into the DIMM.
