S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
9-42
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing the Front Doors and Frame Assembly on the Cisco Nexus 7010 Chassis
Step 5
Align the replacement card to the CompactFlash reader slot as shown in
. The
grooves on the thin side of the card must begin on the end of the card that goes into the reader first.
Step 6
Push the card all the way into the reader.
If the card does not fit easily into the slot, flip the card so the bottom edge is on top, and try pushing the
card into the slot.
Step 7
Wait for the reader LED to turn green and for a message to appear on the console.
•
If you are installing a card into the log flash reader, the message will end with “logflash:online.”
switch# 2008 Mar 15 08:00:00 switch %$ VDC-1 %$ %IDEHSD-2-MOUNT: logflash:online
•
If you are installing a card into the expansion flash reader, the message will end with “slot0:online.”
switch# 2008 Mar 15 08:00:00 switch %$ VDC-1 %$ %IDEHSD-2-MOUNT: slot0:online
•
If you see an offline message or do not see a message, either the card is not fully pushed into the
reader or it is improperly formatted.
switch# 2008 Dec 1 12:00:00 switch %$ VDC-1 %$ %IDEHSD-2-UMOUNT:logflash:offline
Make sure that the card is fully inserted inside the reader. If the card is fully inserted, either format
the card (see the
Cisco NX-OS Fundamentals Configuration Guide, Release 5.x
) or replace the card
with another card that is properly formatted for the reader.
Replacing the Front Doors and Frame Assembly on the Cisco
Nexus 7010 Chassis
If the front door and frame assembly are already attached to the chassis when you need to ship the chassis
or move the chassis from one rack to another, you should remove the front doors and frame assembly for
safer and easier handling of the chassis.
This section describes how to remove and install the front doors and frame assembly, and it includes the
following topics:
•
•
Removing the Front Doors and Frame Assembly, page 9-42
•
Installing the Front Doors and Frame Assembly, page 9-47
Required Tools
You need a flat-blade or number 2 Phillips-head screwdriver to loosen or tighten the screws that hold the
frame members to the chassis.
Removing the Front Doors and Frame Assembly
Removing the optional front doors and frame assembly involves removing the side frames from the EMI
frame, removing the bottom frame assembly, and removing the two front doors.
