S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
9-74
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing the Front Door and Air Intake Assemblies on the Cisco Nexus 7018 Chassis
Figure 9-44
Attaching the Hinge Bracket to the Cable Management Frame and Chassis
Step 7
Tighten the four M4x8 screws that fasten the bottom hinge bracket to the chassis to 11 to 15 in-lb (1.2
to 1.7 N·m).
Step 8
Tighten the four M4x8 screws that fasten the bottom hinge bracket to the cable management frame to 11
to 15 in-lb (1.2 to 1.7 N·m).
Step 9
Fasten the four ball-point studs to the bottom portion of the chassis, one stud by each corner of the air
intake area as shown in
.
1
Four M4x8 pan-head screws that fasten the
bottom hinge bracket to the chassis.
2
Four M4x8 pan-head screws that fasten the
bottom hinge bracket to the left and right sides
of the cable management frame.