S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
9-79
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing the Front Door and Air Intake Assemblies on the Cisco Nexus 7018 Chassis
Figure 9-49
Attaching the Right Side of the Door
Step 16
Swing the door closed so that the remaining two pins on the bottom hinge bracket and top cover fit inside
the slots on the top and bottom of the door. When you close the door, the door stopper automatically
presses the lock button on the inside of the door so that the door is locked on the hinge pins. If the door
stopper does not close the latches, press the door closed at the handle until you hear the latches click.
Make sure that the door is fully secured to the frames on both sides.
Note
If a hinge pin is not secured behind a door latch, open the door handle for that side of the door until it
clicks, open that side of the door, and then press the door closed so that the pins are positioned all the
way inside the door slots. When you close the door, the door stopper automatically closes the door
latches. If you do not hear the latches click, press the door at the handle to fully close it and to activate
the latches. Test the door to make sure that it is fully secured to the four hinge pins.
1
Pull the latch handle outwards until it clicks.
3
Hinge pins.
2
Swing the door closed.
4
Slots for hinge pins.
