S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
9-43
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing the Front Doors and Frame Assembly on the Cisco Nexus 7010 Chassis
Note
If you are installing a new chassis, you do not need to perform this task because the chassis is not shipped
with these assemblies attached to it.
To remove the front doors and frame assemblies, follow these steps:
Step 1
Remove the two lower side frames from the EMI air filter frame by first removing the EMI panel from
the chassis, and then unscrewing the side frame pieces. When done, replace the EMI frame on the
chassis. The following steps explain each of these tasks:
a.
On the EMI panel, which covers the air intake area on the lower front side of the chassis, loosen and
completely unscrew each of the four captive screws that hold the panel to the chassis.
b.
Pull the EMI panel away from the chassis, along with the attached side frame members and optional
air filter (if attached) (see
).
Figure 9-16
Removing the EMI Panel From the Chassis
