S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
B-5
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Appendix B Transceivers and Module Connectors
10-Gigabit X2 Transceivers
Additionally, you can use the following SFP+ transceivers with the OneX Converter Module (part
number CVR-X2-SFP10G) that adapts SFP+ transceivers to X2 ports:
•
SFP-10G-SR
•
SFP-H10GB-CUxM
For information on the SFP+ 10GB transceivers, see the
“10-Gigabit SFP+ Transceivers and Fabric
Extender Transceivers” section on page B-1
identifies the major features of the X2 transceivers, and
shows the transceiver
with its latching sleeve extended (you pull the sleeve out to remove the transceiver from the I/O module).
Figure B-2
10-Gigabit X2 Transceiver (Latching Sleeve Not Extended)
1
Transmit optical bore
5
Transceiver heat sink
2
Receive optical bore
6
Module connector
3
Latching sleeve (retracted)
7
Latch (extended when sleeve is retracted)
4
EMI gasket