S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
E-21
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Appendix E Repacking the Cisco Nexus 7000 Series Switch for Shipment
Repacking the System Components
Figure E-10
Removing the Bottom Hinge Bracket
h.
Remove the bracket from the chassis and place it in the opened box for that bracket.
i.
Fold the box flaps over the bracket and tape them together and to the box.
j.
Loosen and remove the two M3x10 screws that hold the right door stopper to the right cable
management frame. Place the two screws and the door stopper in the small parts bag for the door.
k.
Loosen and remove the two M3x10 screws that hold the left door stopper to the left cable
management frame. Place the two screws and the door stopper in the small parts bag for the door.
l.
Fold the short box flaps over the top, fold the long box flaps over the short flaps, and then tape the
long flaps together and to the box with packing tape.
m.
Loosen the two captive screws on the air intake frame (there is one captive screw on each side) so
that they are no longer in contact with the chassis (see Callout 1 in
).
1
Remove four M4x8 pan-headed screws
from the chassis.
2
Remove four M4x8 screws from the cable
management assemblies (two screws on each side).
