Purpose
Command or Action
switch(config-radius)#
exit
switch(config)#
Displays the RADIUS server group configuration.
(Optional)
show radius-server groups
[
group-name
]
Example:
Step 8
switch(config)#
show radius-server groups
Copies the running configuration to the startup
configuration.
(Optional)
copy running-config startup-config
Example:
Step 9
switch(config)#
copy running-config startup-config
Related Topics
Configuring the RADIUS Dead-Time Interval
, on page 60
Configuring the Global Source Interface for RADIUS Server Groups
You can configure a global source interface for RADIUS server groups to use when accessing RADIUS
servers. You can also configure a different source interface for a specific RADIUS server group. By default,
the Cisco NX-OS software uses any available interface.
SUMMARY STEPS
1.
configure terminal
2.
ip radius source-interface interface
3.
exit
4.
(Optional)
show radius-server
5.
(Optional)
copy running-config startup config
DETAILED STEPS
Purpose
Command or Action
Enters global configuration mode.
configure terminal
Example:
Step 1
switch#
configure terminal
switch(config)
Configures the global source interface for all RADIUS
server groups configured on the device.
ip radius source-interface interface
Example:
Step 2
switch(config)#
ip radius source-interface mgmt 0
Exits configuration mode.
exit
Example:
Step 3
switch(config)#
exit
switch#
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
50
Configuring RADIUS
Configuring the Global Source Interface for RADIUS Server Groups
