4-21
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
Perform the Initial System Configuration
Step 3
Specify the On-failure link behavior.
•
To specify Bypass , press press Enter.
•
To specify Cutoff , type
2
and press press Enter.
Enter On-failure behavior:
1- bypass
2- cutoff
Enter your choice [1]:
Step 4
Specify the admin status of the SCE 1000 after abnormal boot.
•
To specify Not-Operational status after abnormal boot, press press Enter.
•
To specify Operational status after abnormal boot, type
1
and press press Enter.
Enter admin status of the SCe after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
Examples
The following examples present the procedure for configuring the topology-related parameters for
various topologies. Refer the for a summary of appropriate values for the parameters for each topology.
•
EXAMPLE 1:, page 4-21
•
EXAMPLE 2:, page 4-21
•
EXAMPLE 3:, page 4-22
EXAMPLE 1:
Following is a sample topology configuration for a topology using an external switch.
All other parameter values are automatically assigned by the system as follows:
•
Link bypass mode on-failure — Bypass
•
Admin status of the SCE after abnormal boot — Operational
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]: 2
EXAMPLE 2:
Following is a sample topology configuration for a non-redundant bump-in-the-wire (inline) topology.
All values are the system default values, so it is not necessary to type in the response. Simply press enter
at each line.
•
Connection mode — Inline
•
For a non-redundant topology, link bypass on-failure should be Bypass, so that traffic continues to
flow through the link.
•
After operation of the system resumes, and the SCE 1000 reboots, the SCE 1000 will resume
operation. (Admin status after abnormal reboot is Operational.)
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
