B-37
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
December 2006
Appendix B Hardware Specifications
B.5.2 MXP_2.5G_10G Card Specifications
•
Receiver (client side)
–
Maximum receiver level: –1 dBm at BER 1 * 10 exp – 12
–
Minimum receiver level: –14 dBm at BER 1 * 10 exp – 12
–
Receiver: avalanche photodiode (APD)
–
Link loss budget: 8 dB minimum, at BER = 1 * 10 exp – 12
–
Receiver input wavelength range: 1290 to 1605 nm
•
Environmental
–
Operating temperature: –5 to +55 degrees Celsius (+23 to +113 degrees Fahrenheit)
–
Operating humidity: 5 to 95 percent, noncondensing
–
Power consumption: 35.00 W, 0.73 A at –48 V, 119.5 BTU/hr
•
Dimensions
–
Height: 12.650 in. (321.3 mm)
–
Width: 0.716 in. (18.2 mm)
–
Depth: 9.000 in. (228.6 mm)
–
Depth with backplane connector: 9.250 in. (235 mm)
–
Weight not including clam shell: 3.1 lb (1.3 kg)
B.5.2 MXP_2.5G_10G Card Specifications
The MXP_2.5G_10G card has the following specifications:
•
Line (trunk side)
–
Bit rate:
9.95328 Gbps for OC-192/STM-64
10.70923 Gbps with ITU-T G.709 Digital Wrapper/FEC
–
Code: Scrambled NRZ
–
Fiber: 1550-nm single-mode
–
Maximum chromatic dispersion allowance: 1000 ps/nm
–
Loopback modes: Terminal and facility
Caution
You must use a 20-dB fiber attenuator (15 to 25 dB) when working with the MXP_2.5G_10G
card in a loopback on the trunk port. Do not use direct fiber loopbacks with the
MXP_2.5G_10G card. Using direct fiber loopbacks causes irreparable damage to the
MXP_2.5G_10G card.
–
Connectors: LC
–
Compliance: Telcordia GR-253-CORE, ITU-T G.707, ITU-T G.691
•
Transmitter (trunk side)
–
Maximum transmitter output power: +3.5 dBm
–
Minimum transmitter output power: +2.5 dBm
Summary of Contents for ONS 15454 DWDM
Page 38: ...Figures xxxviii Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 54: ...Procedures liv Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 64: ... 64 Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 Chapter ...
