7-3
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 7 Create Channels and Circuits
DLP-G101 View Optical Channel Network Connection Information
•
To search for circuits that originate, terminate, or pass through a specific node, choose
View >
Go to Other Node
, then choose the node you want to search and click
OK
.
•
To search for circuits that originate, terminate, or pass through a specific card, double-click the card
on the shelf graphic in node view to open the card in card view.
Step 2
Click the
Circuits
tab.
Step 3
If you are in node or card view, choose the scope for the search,
Node
or
Network (All)
, in the Scope
drop-down list located at the bottom right side of the screen. Choose
Node
to see all of the circuits on
that node, or
Network (All)
to see all circuits in the network.
Step 4
Click
Search
if you need to search through the list of circuits.
Step 5
In the Circuit Name Search dialog box, complete the following:
•
Find What—Enter the text of the circuit name you want to find.
•
Match whole word only—Check this check box to instruct CTC to select circuits only if the entire
word matches the text in the Find What field.
•
Match case—Check this check box to instruct CTC to select circuits only when the capitalization
matches the capitalization entered in the Find What field.
•
Direction—Choose the direction for the search. Searches are conducted up or down from the
currently selected circuit.
Step 6
Click
Find Next
. If a match is found the circuit will be highlighted. To continue the search, click
Find
Next
again to find the next circuit.
Step 7
Repeat Steps
and
until you are finished, then click
Cancel
.
Step 8
Return to your originating procedure (NTP).
DLP-G101 View Optical Channel Network Connection Information
Step 1
Navigate to the appropriate CTC view:
Note
The following order is the default column sequence, the order might be different on your
screen, depending on your individual CTC setup.
•
To view circuits for an entire network, choose
View > Go to Network View
.
•
To view circuits that originate, terminate, or pass through a specific node, choose
View >
Go to Other Node
, then choose the node you want to search and click
OK
.
Purpose
This task provides information about DWDM OCHNCs and ONS 15454
circuits.
Tools/Equipment
None
Prerequisite Procedures
DLP-G46 Log into CTC, page 2-25
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Retrieve or higher
Summary of Contents for ONS 15454 DWDM
Page 38: ...Figures xxxviii Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 54: ...Procedures liv Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 64: ... 64 Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 Chapter ...
